Proper use of seat belts

Construction site, high operations, overlapping cross operations are very much. In order to prevent the operator from falling at a certain height and position, the operator must wear a harness when working at heights and heights. There are several requirements for the use and maintenance of seat belts:

(1) The role of seat belt must be attached importance in thought. In countless cases, the seat belt is a lifesaver. But there are a few people feel that the belt trouble, up and down walking is not convenient, especially some small work, temporary work, think that "there is a belt of time work is done". As everyone knows, the accident happens in an instant, so high work must be in accordance with the requirements of the safety belt.

(2) Before using the safety belt, it should be checked that the rope has no deterioration, whether there is a crack in the clip ring, and whether the spring bounce is good.

(3) If the safety belt has no fixed hanging place, appropriate strength of steel wire rope or other methods should be used. Do not hang the safety belt on moving or pointed or unsecured objects.

(4) high hanging low use. When the safety belt is hung up high, the person working below is called high hanging and low use. This is a relatively safe and reasonable method of scientific qualification. It can reduce the actual impact distance when a fall occurs. The opposite is to hang low and use high. It's when the seat belt is hanging low and the person is working on it. This IS A very UNSAFE METHOD OF mounting, BECAUSE when the fall occurs, the actual impact distance will be increased, and both the person and the rope will be subjected to a large impact load. Therefore, the safety belt must be high hanging and low use, to prevent low hanging and high use.

(5) The safety belt should be tied to a strong component or object, to prevent swing or collision, the rope can not be knotted, the hook should be hung on the connecting ring.

(6) The protective sleeve of the safety belt rope should be kept intact to prevent the rope from being worn. If the protective cover is damaged or fallen off, a new cover must be added before use.

(7) It is strictly prohibited to use the safety belt without authorization. If a rope of 3M or more is used, a buffer must be added. Do not remove any parts.

(8) Check whether all parts of the safety belt are intact before use. After using the safety belt, pay attention to maintenance and storage. Always check the sewn part and hook part of the safety belt, and check the twist line carefully for breakage and damage.

(9) The safety belt should be properly kept when not in use. It should not touch high temperature, open flame, strong acid, strong alkali or sharp objects. It should not be stored in a damp warehouse for safekeeping.

(10) The safety belt should be sampled once after two years of use, and the appearance inspection should be carried out frequently after frequent use. If any abnormality is found, the safety belt must be replaced immediately. Seat belts that have been used in regular or sample tests shall not be used again.

Address: Room 18F-B. NO. 1089, Pudong Ave. Pudong New District, Shanghai. China

Customer Service Hotline: +86-21- 3882 1885

Email address : eastchina@ecasc.com

Copyright◎2022 Fortune Tree International Ltd .   沪ICP备19036047号-1 备案号    BY : xinnet